The overlay draws animated falling snow over a transparent background. Flakes near you are larger, faster and brighter than flakes far away, so the snow has depth, and each one sways a little as it falls. It is drawn by the page itself, with no pictures to download. It needs no account and no key, and it asks no other service for anything.
Build it
Open the Snowfall builder, from the Tools page or from the Christmas & Winter section of Seasonal tools. The preview at the top is the real overlay. Move a slider and it reloads a moment later. Copy URL and Open are always on, because every setting has a starting value. See Add a tool to OBS for the browser source.
The snow
- Density
- From 1 to 100. The start is 50. How much snow is in the frame at once. A larger frame holds more flakes at the same density, up to a limit.
- Fall speed
- From 1 to 100. The start is 50. Flakes far away fall slower than near ones.
- Smallest flake (px)
- From 1 to 40. The start is 2. The size of the farthest flakes.
- Largest flake (px)
- From 1 to 40. The start is 7. The size of the nearest flakes. It is never smaller than the smallest flake, so the builder raises it if you drag the smallest above it.
- Wind
- From 100 to the left to 100 to the right. The start is none, so the snow falls straight down apart from its sway. Near flakes drift further than far ones.
- Opacity
- From 10% to 100%. The start is 80%. Far flakes are always fainter than near ones.
- Flake color
- White to start. Pick a pale blue for a colder look, or any other color.
When you change the density while the overlay runs, new flakes arrive from above the top edge and surplus flakes keep falling until they leave the bottom, so the snow never jumps.
Landscape and portrait
The overlay fills the whole browser source, whatever its size. Set the source to the size of your stream's frame, such as 1920 by 1080 for landscape or 1080 by 1920 for portrait. The same amount of snow falls over the whole frame either way. In the builder, Landscape and Portrait only change the shape of the preview, and they are not part of the link.
Performance
- There is a limit on how many flakes are drawn at once, however large the source is and however high the density, so it stays light on a phone.
- The picture is drawn at no more than twice the size of the page, which a very sharp phone screen would otherwise make heavier than the snow needs.
- It stops while the page is hidden, such as a browser source that is not shown, and carries on from where it was when it is shown again.
Use it with other overlays
Snowfall is its own browser source. It does not depend on any other seasonal overlay, so you can add it beside the others as separate sources and stack them in the order you like.
Advanced: change it in the link
Everything the builder does is a setting in the link after the #. Your browser does not send that part to our server. Only settings you change are written, so a link with no settings at all is the starting snow.
| Setting | Values | Starts as |
|---|---|---|
density | 1 to 100 | 50 |
speed | 1 to 100 | 50 |
minsize, maxsize | 1 to 40 pixels | 2, 7 |
wind | -100 (left) to 100 (right) | 0 |
opacity | 10 to 100 | 80 |
color | a color such as aaccff | ffffff |
A setting that is missing or not valid takes its start value, and a number outside its range is held to the nearest end of it.